![]() (This lets the system create a curve structure for your Uni fans. Step 5: Boot into Windows and from that point on, open your AI Suite and have the Fan Expert run the Automatic Fan tuning. My plug is located at the bottom and the fan is labeled as Chassis Fan 3 (CHA3_FAN on MOBO I think, If you don't know, refer to your manual). There, change the corresponding fan plug on the MOBO to PWM mode (by default I think it says auto). Step 4: Boot into your BIOS and locate Q-Fan control. Step 3: Take the PWM lead you just disconnected and plug it into the chassis fan header you had the single PWM lead going to from the controller. Step 2: Disconnect one of your fan/group PWM plug from the Lian-Li controller (DO NOT DISCONNECT anything else, keep the RGB plugged into the controller). Step 1: Shut-off PC, disconnect the PWM lead (It is paired with the RGB connector (keep that plugged in), it's the single wire plug you need to disconnect from the MOBO) from the chassis fan header. ![]() *Disclaimer* I am tired after troubleshooting all day so if you have any questions, lmk.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |